Pulled Beef Sandwich

Pulled Beef Sandwich

For this recipe I’m shooting for more of a beefy flavor than typical bbq, so the seasoning I use is savory based. I take my AP seasoning (Salt, Pepper, Garlic) and add a few things to it.

1/2 cup Salt
1/4 cup Garlic
1/4 cup Onion Powder
1/4 cup Chili Powder
1/8 cup Black Pepper
1 tea Ground Parsley
1 tea Ground Oregano

Season all sides of the chuck roast with this mixture (it’s more than enough seasoning for 2)

Now it’s time to light the fire. I’m looking for 250 degrees with a little mild pecan smoke for these chucks. Once the smoker is up to temperature, place the roasts directly on the grate and close the lid.

I’m using my Yoder (set & forget) today but any cooker will work as long as you can regulate the heat.

After 1.5 hours flip both roasts over and continue smoking. Keep adding pecan chunks as necessary and maintain the temperature at 250 degrees.

At the 3 hour mark the chuck roasts should be ready to pan. Take a thermometer reading here; it should read between 140-150 degrees. The meat won’t take any more smoke at this point, so it’s best to get it covered.

For these chuck roasts, I use a large steam pan to hold them both. The meat needs some additional liquid as well, so I pour in 32oz of warmed beef broth. If you want to change it up a little substitute red wine or even a dark beer, go for it.
Cover the pan with aluminum foil and place it back on the smoker still holding 250 degrees.

You’re looking at another 2-3 hours at least, so keep an eye on the pit and add fuel as needed.

You want to go more by the internal temp that the time – and the final target temperature is 195-200 internal. It’s not the end of the world if you overshoot the target temp on this cut of meat. There’s plenty of liquid in the pan to add moisture and you want it falling apart. This beef is for pulling, so we want the collagen and fat holding it together to completely dissolve.

When the thermometer is reading 195 and it feels like a knife sliding into hot butter, you know it’s done. Remove the pan from the smoker and let the steam escape for about 5 minutes. Rest the meat for at least an hour (I go for 2) before breaking it down. Even after two hours it will still be so hot you’ll need to wear hand savers and gloves.

When it’s done properly this meat will practically pull itself. Separate any fat that didn’t render and pull the pieces into small strands. If you don’t want to shred it by hand you can always use a couple forks or a pork puller… it will flake right apart after it cools a little.

Source: HowToBBQRight Malcom Reed